All those tools have poor design, for example the window is not resizable, so it’s impossible to your an old netbook (1024×600 resolution), and then you have to install drivers which is easy, for after detection of the box may be hit and miss, and you have to follow a procedure with the right power sequence with a USB cable connected to a USB OTG port (not always properly marked) and the recovery pin hole or button. Be patient, and DON'T interrupt it! It's working hard! When it finishes up it'll automatically boot up and show picture and you be with your GT1 Mini Home screen shown again.In the first few years when Android TV Boxes/mini PCs started to hit the markets, in the 2012-2014 period, online firmware update was inexistent for the vast majority of the boxes, and if you wanted to update your firmware you had to use some windows tools like USB Burning Tool for Amlogic, AndroidTool for Rockchip, or PhoenixUSBPro / PhonixSuite for Allwinner platforms. Unhook the USB cable from it, hook it back up to your TV, start it the GT1 Mini up and there may not be any picture, or signal on the TV for up-to 5 minutes.

When successfully completed the green progress bar under ' Status ' category, will state ' 100% : Burning successfully '. USB v1 Port will require use of GT1 Mini power adapter for the needed power.ħ) Use a toothpick or a paper-clip and stick it into the device factory RESET hole ( found underneath of the box ) and carefully push and HOLD the RESET button down.Ĩ) While holding the RESET button down, plug in the other end of the USB cable into the device USB OTG port (this'll be the USB v2 BLACK Port.) The Amlogic USB Burning Tool should automatically detect your connected device and you can now release the RESET button.ĩ) Now simply click the ' Start ' button on the Amlogic USB Burning Tool screen. erter/dp/B015OMSQWM )ġ) Download Amlogic USB Burning Tool package.Ģ) Right-click on Amlogic USB Burning Tool package and use ' Run as Administrator ' to install.ģ) There also be request to install WorldCub drivers, and you'll need to accept.ĥ) In the Amlogic utility menu visit File -> Import Image, and select your USB flash firmware to be applied to your Amlogic device.Ħ) Plug the USB cable into the PC v2 or v3 USB Port. Visit the following link and download setup_v2.1.6.8.exe ( Amlogic USB Burning Tool v2.1.6.8 )ģ) USB Male-to-Male Cable or USB Male-to-Female Cable with USB Male-to-Male Adapter end (. * Reload the firmware to possibly fix issues experienced.Ģ) Amlogic USB Burning Tool ( GT1 Mini needs at least version 2.1.6.8 or newer to be used.

* Upgrade to the latest firmware for your device. Amlogic USB Burning Tool is a PC tool to flash USB flash firmwares to Android devices powered by Amlogic processors.

Usb burning tool 2.1.6.8 download